configuring the zmodo ZP-IBi-13W camera to work with Blue Iris Software.
Off topic.......configuring the zmodo ZP-IBi-13W camera to work with Blue Iris Software.
Many people have had issues getting these cameras to display video in any other sotware except the supplied z-viewer. Here is how I got it working with the Blue Iris Software. The settings may work with other software but have not been tested.
Many people have had issues getting these cameras to display video in any other sotware except the supplied z-viewer. Here is how I got it working with the Blue Iris Software. The settings may work with other software but have not been tested.
Pre-Requisites
First
set the camera up using the instructions with the camera using zviewer and
zsight software.
You
will need to find the cameras wireless ip address. If possible set this statically by connecting
to the cameras IP address using internet explorer. ..http://ip-of-camera... Note it does not work with Firefox of chrome.
Once
working you need to install Blue Iris Software on a machine which can contact
the cameras. Usually this will be
sitting on the same network but it will work over a router network providing the required ports are allowed
Blue Iris Installation
Load
up the Blue Iris Software and Add a new camera
On
the video tab tick the option for Anamorphic (force size) then type 1280 x 720.
Select
Max.rate 25.00 fps.
Click
configure
Now the important settings:
Using the IP address of your camera, enter it in the address
field.
Set the port to 9000
Set Make to Zmodo
Set Model to ISV-BFS2 etc……..(mobile port)
The other two option I selected are circled below also.
Click okay and all being well your camera will display.
Also you can configure the Motion Capture and record
settings as required allowing video to be captured.
Comments
Post a Comment